HansaManuals Home   >> Standard ERP   >> Piegādātāji   >> Settings  

Iepriekšējā   Nākamā               Rādīt visu nodaļu               Meklēt  

Šis apraksts rakstīts programmas versijai 7.2  

Number Series - Payments

Each Payment has its own unique identifying number, based on a sequential series. When you enter a new Payment, the next number in the sequence will be used. If required, you can have a number of such sequences running concurrently, perhaps representing different years or different departments.

Use this setting to define these sequences, or Number Series. The different series should not overlap. If you leave the setting empty, Payment Numbers will start at 1 and continue consecutively.

Once you have defined number sequences for Payments, you can allocate a specific sequence to an individual user using the Payment No. field on the 'Number Series' card of the user's Person record in the System module. When that user enters a new Payment, its Payment Number will be the first unused number in that specific sequence. You can also set a universal default sequence in the Number Series Defaults setting, also in the System module. If you do not allocate a specific sequence to a particular user or set a universal default, Payment Numbers will be taken from the first valid Number Series in this setting. For a particular Payment, any user can change to the first unused number in any other valid Number Series using 'Paste Special'.

The N/L field gives you a measure of control over whether Nominal Ledger Transactions will be generated automatically when you mark Payments in a particular sequence as OK and save them. Using 'Paste Special' from the N/L field brings up a selection list containing two options: "GenTrans" and "Do Not GenTrans". Select the first option if Nominal Ledger Transactions are to be generated and the second if they are not. In effect, this feature is an exclusionary one in that you can only choose to not have Nominal Ledger Transactions created for a particular number sequence. If the overall preference (set in the Sub Systems setting in the Nominal Ledger) is to not have such transactions created, you cannot decide to have them created for a single sequence.

When you double-click 'Number Series - Payments' in the 'Settings' list, the following window appears:

Enter each new Number Series on the first blank line. The Comment will be shown in the 'Paste Special' list, so enter some text that will help you choose a number from the correct sequence. Then, when finished, click the [Save] button in the Button Bar to save the changes. To close the window without saving changes, click the close box.

Note that you can also define separate Number Series for each Payment Mode: please refer to the page describing the Payment Modes setting for details. If you are using the Common Number Series option in the Cash Book Settings setting in the Cash Book module, the number sequences in Payment Modes must be different to those entered here.

---

Settings in the Purchase Ledger:

• Introduction
  

• Account Usage P/L
  

• Bank Transfer
  

• Banks
  

• Calculation Formulae
  

• Intrastat Purchase
  

• Number Series - Payments
  

• Number Series - Purchase Invoices
  

• Payment Codes
  

• Payment Modes
  

• Payment Settings
  

• Payment Terms
  

• Purchase Invoice Settings
  

• Supplier Categories
  

• Supplier Withholdings
  

• VAT Accounts
  

• VAT Corrections P/L
  

• Withholding Calculation Formulae
  

• Withholding Certificates
  

• Withholding Taxes

Go back to:

• Home page for Purchase Ledger manual
  

• Home page for HansaWorld Enterprise manual

Iepriekšējā   Nākamā   Uz augšu            Rādīt visu nodaļu