This page describes using Access Groups to determine the module that users will see when they log in to your Standard ERP system. Please refer to the following pages for more details about other aspects of Access Groups:

---

By default, the Nominal Ledger will be the first module that you will see when you log in to Standard ERP. If you want another module to be active on log-in, you can change this default using Access Groups. Simply specify that module in the first row of the matrix.

If the only purpose of the Access Group is to specify the active module on log-in (i.e. you do not want to restrict access in any way), there's no need to enter anything else in the matrix, as shown in the illustration below.

If the Access Group will be more complex, you should still use the first row to determine the active module on log-in.

A member of the Access Group illustrated above will see the Stock module when they log in to Standard ERP. If their Person record that Starts from Full Access and you give Full Access to the module as shown in the illustration, then access to the Stock module and to the other modules will not be restricted at all. If their Person record Starts from No Access, they will only have access to the Stock module.

Please refer to the following pages for more information about Access Groups:

---

Go back to:

Home page for Settings in the System module
Home page for System Module manual
Home page for Standard ERP manual

Previous Next Top Entire Chapter in Printable Form